Group B 930

Porsche 911 Roll Cage Installation

Step 1 - Set Car On Level Floor

911 on Rack

Set up the 911 on a level floor or alignment rack.

Step 2 - Assemble Cage in Car

Rear Cage Contacts Strap to Secure Cage

Assemble the 4 section of the roll cage in the car (Front, Back, 2 Sides). If you have an interior, you will need to pull back the carpet.

Step 3 - Mark and Prep Contact Points

Front Holes Cage Mounting Plate Rear Contacts Holes Too BIG!

Using a permanet marker, mark where the roll cage contacts the floor. Make sure to mark the centers to drill out holes for the nuts in the cage mounting plate. NOTE: The holes in the front are bigger than the holes in the rear. Don't make my mistake and make the holes in the back too a big. They only need to be as big as the bolt holes on the cage rear contact pad on the wheel well

Step 4 - Weld Front and Center Mount Plates

Welded Contacts Center Weld Front Web

The front and center contact points are on welded plates. The rear contact point uses a sandwich style clamp.

Step 5 - Seal and Protect Welds

Seal Welds Center Weld Sealed

Use a paintable rubber sealer (3M) to protect welds.

Step 6 - Paint Roll Cage

Painted Cage

Paint the cage and contact points.